ALTERA DOES NOT WARRANT THAT THE FUNCTIONS CONTAINED IN THIS PATCH WILL MEET YOUR REQUIREMENTS, OR THAT THE OPERATION OF THIS PATCH WILL BE UNINTERRUPTED OR ERROR-FREE. //**************************************************************** quartus-10.0-1.113-readme.txt Readme file for Quartus II 10.0 SP1 Patch 1.113 Copyright (C) Altera Corporation 2010 All right reserved. Patch created on September 15 2010 Patch SPR#: 352840 SPRs fixed: 348995 //**************************************************************** Problem: Remote Update IP in SOPC builder does not set the operation_mode parameter of the remote update block wyswiyg. If a design uses this IP and the selected configuration scheme is active parallel, Quartus II 10.0sp1 will issue an error about the operation_mode parameter of the Remote Update block wysiwyg has not been setup correctly. This problem only affects Cyclone III and Cyclone IV E. Solution: The patch will lift the requirement that the value of the Remote Update block's operation_mode has to match the selected configuration scheme. The operation_mode parameter is not needed for Cyclone III and Cyclone IV E. Caution - You must either have previously installed the Quartus II 10.0 SP1 software or must install the Quartus II 10.0 SP1 software before installing this patch. Otherwise, the patch will not be installed correctly and the Quartus II software will not run properly.