Issue 137246: Version 1.1
If the JTAG connections are not used, you need to connect the TCK to GND, TDI and TMS pin to VCC.
Issue 132325: Version 1.1
The pin connection guidelines for MSEL[0..3] incorrectly state these pins are internally connected to 5-K. resistor to GND. The correct internal resistor is 9- K..
Issue 110148: Version 1.1
The pin connection guidelines for TDI and TMS state these pins should be connected to VCC when disabling JTAG. The proper VCC connection is described below:
1) 2.5V/3.0V/3.3V configuration voltage standards, the VCC refers to VCCA.
2) 1.5V/1.8V configuration voltage standards, the VCC refers to the VCCIO supply of the bank in which the JTAG pins reside.
Issue 10001979, Version 1.0
The Cyclone® III Pin Connection Guidelines is missing information on the DATA[7..2] pins. The information that will be added can be found in the Configuring Cyclone III Devices (PDF) Chapter of the Cyclone III Handbook on Table 10-20.
Issue 10006679, Version 1.1
The Cyclone III Pin Connection Guidelines has information on a RDY pin but this pin is not available and is already removed from the Cyclone III pinouts. This pin will be removed from a future version of the Cyclone III Pin Connection Guidelines.