Intel® Quartus® Prime Standard Edition User Guide: Power Analysis and Optimization

ID 683506
Date 9/24/2018
Public
Document Table of Contents

2.5.1.1. Clock Enable in Memory Blocks

In memory blocks, power consumption is tied to the clock rate, and is insensitive to the toggle rate on the data and address lines. Memory consumes approximately 20% of the core dynamic power in typical designs.

When a memory block is clocked, a sequence of timed events occur within the block to execute a read or write. The circuitry that the clock controls consumes the same amount of power, independent of changes in address or data from one cycle to the next. Thus, the toggle rate of input data and the address bus have no impact on memory power consumption.

The key to reducing memory power consumption is to reduce the number of memory clocking events. You can achieve this reduction through network-wide clock gating, or on a per-memory basis through use of the clock enable signals on the memory ports.

Figure 14. Memory Clock Enable SignalLogical view of the internal clock of the memory block. Use the appropriate enable signals on the memory to make use of the clock enable signal instead of gating the clock.

The clock enable signal enables the memory only when necessary, and shuts down for the rest of the time, reducing the overall memory power consumption. You include these enable signals when generating the memory block function.

Figure 15. Clock Enable in RAM 2-Port

For example, consider a design that contains a 32-bit-wide M4K memory block in ROM mode that is running at 200 MHz. Assuming that the output of this block is only required approximately every four cycles, this memory block consumes 8.45 mW of dynamic power according to the demands of the downstream logic. By adding a small amount of control logic to generate a read clock enable signal for the memory block only on the relevant cycles, the power can be cut 75% to 2.15 mW.

You can also use the MAXIMUM_DEPTH parameter in your memory IP core to save power in Cyclone® IV GX, Stratix®  IV, and Stratix® V devices; however, this approach might increase the number of LEs required to implement the memory and affect design performance.

The Intel® Quartus® Prime software automatically chooses the best design memory configuration for optimal power. However, you can set the MAXIMUM_DEPTH parameter for memory modules during the IP core instantiation.

Figure 16. RAM 2-Port Maximum Depth