Intel Agilex® 7 Device Family High-Speed Serial Interface Signal Integrity Design Guidelines

Download PDF
ID 683864
Date 6/15/2023
Public
Document Table of Contents
Document Table of Contents x
1. Signal Integrity (SI) in High-Speed PCB Designs
1. Signal Integrity (SI) in High-Speed PCB Designs x
1.1. Supported Protocols 1.2. Channel Insertion Loss (IL) Budget Calculation 1.3. PCB Materials and Stackup Design Guidelines 1.4. PCB Design Guidelines 1.5. Document Revision History for the Intel Agilex® 7 Device Family High-Speed Serial Interface Signal Integrity Design Guidelines
1.3. PCB Materials and Stackup Design Guidelines x
1.3.1. Mitigating Insertion Loss with Dielectric Material 1.3.2. Power Layers 1.3.3. Reference Planes 1.3.4. Layer Assignment 1.3.5. Impedance 1.3.6. Via Drill Size 1.3.7. Fiber Weave 1.3.8. Reference Stackup
1.4. PCB Design Guidelines x
1.4.1. General PCB Design Guidelines 1.4.2. E-Tile PCB Design Guidelines 1.4.3. F-Tile PCB Design Guidelines 1.4.4. P-Tile PCB Design Guidelines 1.4.5. R-Tile PCB Guidelines
1.4.1. General PCB Design Guidelines x
1.4.1.1. PCB Traces 1.4.1.2. PCB Vias 1.4.1.3. Connector Breakout 1.4.1.4. AC Coupling Capacitor 1.4.1.5. Others
1.4.3. F-Tile PCB Design Guidelines x
1.4.3.1. F-Tile Features and Capabilities 1.4.3.2. Optimizing the Passive Channel 1.4.3.3. COM Simulations 1.4.3.4. Simulating the Active Channel
1.4.5. R-Tile PCB Guidelines x
1.4.5.1. R-Tiles Features and Capabilities 1.4.5.2. R-Tile Design Layout Examples 1.4.5.3. Landing Pad Cut-out Optimization of AC Coupling Capacitor 1.4.5.4. R-tile HSSI Breakout Routing in BGA Field Area and MCIO connector Pin Area 1.4.5.5. AC Coupling Capacitor Placement Around MCIO Connector 1.4.5.6. PCIe Gen5 Add-in Card Edge Finger Breakout Design Guidelines
1. Signal Integrity (SI) in High-Speed PCB Designs

1.4.3.4. Simulating the Active Channel

Passive channel simulation checks most board designs. However, Intel suggests performing active channel simulation (eye diagram simulation with IBIS-AMI model) to further capture the channel behavior with TX and RX devices.
  1. Contact Intel for the F-tile IBIS-AMI model and user guide.
  2. Cascade the IBIS-AMI model with the optimized passive channel model in channel simulation tools.
  3. Tune the TX PMA parameter (auto adaption for RX).
  4. Run channel simulations to get the optimized eye diagram.
    Typically, any non-zero open eye means the channel can work, but you should optimize the TX PMA setting for the best eye opening at the target BER level, to get the best design margin.
Level Two Title