AN 967: Multiple Device Synchronization in Digital Phased Array System

Download PDF
ID 734485
Date 12/15/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Digital Phased Array Synchronization 3. Multiple Device Synchronization in DPA System 4. Test Result 5. Conclusion 6. Document Revision History for AN 967: Multiple Device Synchronization in Digital Phased Array System A. Appendix
3. Multiple Device Synchronization in DPA System x
3.1. JESD204(A/B/C) Interface 3.2. Clock/SYSREF Scheme 3.3. FPGA Design Synchronization 3.4. Data Exchange between FPGA Devices 3.5. Event Trigger Synchronization
3.2. Clock/SYSREF Scheme x
3.2.1. clk_ref 3.2.2. clk_dev and SYSREF 3.2.3. SYSREF Capture
3.3. FPGA Design Synchronization x
3.3.1. Data and SYSREF Clock Domain Crossing 3.3.2. Data Transformation when Clock Domain Crossing
3.5. Event Trigger Synchronization x
3.5.1. SYSREF Distribution
A. Appendix x
A.1. FPGA I/O Timing Constraints for SYSREF
A.1. FPGA I/O Timing Constraints for SYSREF x
A.1.1. Source-Synchronous Interface Timing Constraints A.1.2. SYSREF I/O Timing Closure
A.1.2. SYSREF I/O Timing Closure x
A.1.2.1. Adjust Input Delay Chain Value A.1.2.2. Using PLL to Adjust clk_dev Phase A.1.2.3. Place First SYSREF Capture Register in IOE
1. Introduction
2. Digital Phased Array Synchronization
3. Multiple Device Synchronization in DPA System
4. Test Result
5. Conclusion
6. Document Revision History for AN 967: Multiple Device Synchronization in Digital Phased Array System
A. Appendix

A.1.2.3. Place First SYSREF Capture Register in IOE

To place the first SYSREF capture register in the IOE, set Fast Input Register On in Quartus -> Assignment Editor, shown in the following figure sysref_in is the pin name of the SYSREF in the FPGA project.
Figure 21. Fast Input Register Setting

After FPGA project compilation, you can check the result by right-clicking the SYSREF pin name and then click Locate Node->Locate in Resource and Property Viewer, as shown in the following figure.

Figure 22. Launch Resource Property Viewer

If the register is placed in the IOE successfully, the input register in the IOE is highlighted in the Resource and Property Viewer, shown in the following figure.

Figure 23. Place Input Register in IOE
Level Two Title